Fascinated with the form of the tripot, and interested to see what was involved in making one, I have started my own. I couldn’t think of a better way to understand and appreciate it than to make one myself.
In my first article about making my tripot, I showed how I shaped most of the exterior using a router and lathe together. Since then, I hollowed out each vessel starting with a drill bit to establish the depth of each pot, then using turning tools to reduce the wall thickness and shape the interior. For each pot, I had to mount the pot being worked on centred on the lathe axis, then mount counterbalances to allow the lathe to run without excessive vibration.
To accomplish this, I attached a disc of 1/2″ plywood between the face plate and tripot to which I strategically screwed scrap wood opposite to the bulk of the off-axis tripot mass. Pieces of the first tripot attempt worked perfectly.
After drilling out the centre with a drill bit mounted in the tailstock, I used a bowl gouge to hollow the vessel. A purpose-built hollowing tool would have allowed me more freedom in design (for example, creating more of a vase shape and less of a bowl shape) and provided greater control and safety, but since I don’t own such a tool and wasn’t prepared to purchase one, I made do. My confidence with the bowl gouge improved substantially with these intimidating cuts – many of which were well beyond the tool rest in tight quarters.
After hollowing each pot, I sanded the inside to completion, working through grits from 80 to 220. I found that Mirka Abranet cut more quickly than any of the abrasive papers I tried. Sanding the inside of small pots is not fun, and I wanted to finish and move on as quickly as possible. To assist in sanding, I improvised a tool to sand the inside bottoms by applying adhesive-backed hook strips to a 1/2″ steel drill rod.
To this tool, I attached the loop-backed strips of Abranet and chucked it in a heavy-duty drill for power sanding and ran the drill clockwise while the lathe turned the pot counter-clockwise.
While it might be safe and acceptable to hold sandpaper in your hand to sand the inside of a larger bowl, the small scale of this vessel, coupled with the fact that there are several other larger pots whirling around it, meant that I didn’t want my hands anywhere near the workpiece. So I chucked up a sleeveless sanding drum in my drill and fitted it with a piece of Abranet. I intentionally left it proud of the drum’s end to help sand the transition from side wall to bottom.
Again, I ran the lathe and drill in opposite directions This made for an efficient and satisfying sanding experience.
After all three pots were hollowed and sanded, I took the tripot off the lathe and cut off the waste at the base using the bandsaw.
I turned a tenon on a piece of clear pine to exactly fit the opening of the largest vessel and used this jam chuck to mount the tripot on the lathe facing the opposite direction to shape the base.
I tried using a pointed live centre before switching to a cup centre which allowed me to adjust the positioning of the bottom of the pot to ensure the pot was running fairly true.
I used a bowl gouge to turn the bottom round as far as I could without removing too much material from the other two pots.
This video (7:47) shows how the base was turned.
Then I created another jam chuck for the next tripot vessel and repeated the process, before sanding and carving to refine the shape. That’ll be the focus of the next segment on making my tripot.