I kept this Drill Press Stand with the idea that it would help me accurately bore 3/4″ holes for bench dogs. Then, when I set out to drill them I realized that the drill only has 2 amps and that my larger drill could not be properly installed in the stand. That meant that I had no use for it.
This Drill Press Stand would probably be ideal for drilling smaller holes or running a wire wheel brush.
The drill is lowered in a controlled manner with the feed lever on the right side and the whole assembly can be raised or lowered along the post, as well as swiveled to sit away from the base to drill long stock.
The same goes for the table, which can also be rotated.
The keyed chuck accepts bits up to 3/8″ diameter and the key has a handy storage spot on the stand.
Okay, here’s the deal.
If you would like this drill and Drill Press Stand, please leave a comment below indicating your interest by 10am of April 25.
I will then draw a winner at random. Even if you don’t get this item, remember that there is still much more I want to give away.
And if you haven’t already, be sure to subscribe to my blog so you can be notified as soon as I post something new! Please tell your friends about my Overflow program.